Whether you’re considering a Structural External Wall Insulation system or a standard EWI system, the choice of finishes remains the same. From a traditional render to a brick effect finish Structherm have textures, effects and colours to suit all projects.

Renders

Crack resistance

Highly flexible due to the synthetic resin binders which are highly elastic therefore providing excellent resistance to surface cracks in comparison to traditional cement based renders.

 

Excellent adhesion

Can be applied to a wide range of substrates, including our External Wall Insulation and Structural External Wall Insulation systems as well as render carrier board, concrete and masonry.

Weather resistant

Polymer modified renders provide excellent water repellency as well as resistance to stressing climatic conditions such as frost and thaw, UV rays, acid gases and pollution.

Water vapour permeable

High water vapour permeability, or breathability, enables the humidity within a buildings structure to be released unhindered into the environment, avoiding moisture build up between coating and substrate.

Through coloured

Over painting is not required as all our renders are through coloured to provide long lasting protective coatings. Everyday wear and tear does not affect the finished appearance of the system.

Colours & Texture

Colour and texture in architecture is a critical element in every project. That’s why, in addition to a standard range of 20 colours, Structherm can also supply a colour plan swatch containing more than 200 additional colours to choose from along with a variety of different textures. We may also be able to produce to a specific colour reference on a project specific basis should this be required.

We believe we have access to the largest colour range in the industry – In addition to the standard colours below, we can also match to existing buildings.

Vantage Pro 1.5mm Silicone

This colour chart shows the standard colours of our VantagePro Silicone range.

Struc-Sil 1.5mm Silicone

This colour chart shows the standard colours of our Struc-Sil Silicone range

Dash Finishes

Structherm’s range of Dash Receiver and Aggregate provides a decorative, durable and cost effective finish applied in two stages. The final aesthetic appearance depends on the combination of coloured dash receiver and aggregate chosen.

Dash Receivers

Dash receiver is a specially formulated polymer modified through colour render that provides excellent adhesion and impact resistance. A standard colour range is available.

The dash receivers should be hand applied onto an appropriate basecoat using a hawk and trowel to a thickness of 6-8 mm.

Struc-Dash - Dash Receiver

This colour chart shows the standard colours of our Struc-Dash dash receiver range.

VantagePro Dash Receiver

This colour chart shows the standard colour chart for our VantagePro dash receiver range.

Iron Free Aggregate

The high quality decorative dash aggregates allow you to not only create classic rendered pebble dashed walls, but also some very unique styles with our wide range of colours available.

The dash aggregate is thrown onto the surface of the dash receiver, whilst still wet, in an upward motion using a hand scoop.

For best results an even distribution of aggregate is necessary and any missed areas should be rectified immediately as it
can not be touched up next day.

Apart from our own standard range of aggregates it is possible to use regional or locally sourced materials

Dash Aggregates Colours

Standard colours for our dash aggregate finishes.

Alternative finishes

It’s now possible to replicate the appearance of brick through the use of through coloured renders.

A coloured basecoat is applied to replicate the mortar and a brick coloured scratch coat applied over the top.

The top coat render is then cut through to expose the mortar layer and hence create the brick effect finish.

Art Brick Brick Effect Resin

Information pack on ArtBrick finishes.

ArtBrick Pack

Share This